1983 Ford Bronco Review

Main Specs Gallery Trims Vin Numbers Recalls Faq

Crash Testing 0

# Trims 1 Trims

1983 Ford Bronco is a Sport Utility 2-dr style car .Made in United States, 1983 Ford Bronco has 1 trim priced by the manufacturer at 0 with just total of 2 recalls in the past 1983 Ford Bronco. It’s seating No data people with doors and a rank size of No data gallon. The engine is 5.8L V8 OHV 16V .

Exterior Photos

Interior Photos

Ford Bronco 1983 Trims

1983 Ford Bronco 4WD

Engine: 5.8L V8 OHV 16V

Drivetrain: 4WD

Body & Doors: SPORT UTILITY 2-DR

Vin Numbers

1FMDU15F7DLA63847
1FMEU15F4DLA36061
1FMEU15G8DLA20180
1FMDU15FXDLA74101
1FMDU15Y5DLA02059
1FMEU15FXDLA57268
1FMEU15F5DLA24369
1FMDU15G9DLA28655
1FMEU15F5DLA27613
1FMEU15F0DLA32136
1FMEU15G5DLA08732
1FMEU15G8DLA02018
1FMEU15G6DLA33865
1FMEU15G6DLA44140

Safety & Recalls

Recall 07E064000 started on /Date(1188187200000-0400)/.

Summary: CERTAIN FEDERAL-MOGUL AFTERMARKET FUEL PUMPS SOLD UNDER THE BRAND NAMES OF CARTER, ACCUFLOW, NAPA, TRUFLOW, PARTS DEPO, AND PARTS MASTER, SHIPPED BETWEEN AUGUST 2006 AND JULY 2007 FOR USE ON THE VEHICLES LISTED ABOVE. THE FUEL PUMP DIAPHRAGM IN CERTAIN PRODUCTION RUNS MAY HAVE BEEN IMPROPERLY INSTALLED OR INADEQUATELY TESTED WHICH MAY CAUSE THE FUEL PUMP TO LEAK.

Consequence: A LEAKING FUEL PUMP COULD CREATE A VEHICLE FIRE HAZARD.

Remedy: FEDERAL-MOGUL WILL NOTIFY OWNERS AND REPLACE THE DEFECTIVE FUEL PUMPS FREE OF CHARGE. THE RECALL BEGAN ON OCTOBER 15, 2007. OWNERS CAN CONTACT FEDERAL-MOGUL AT 248-354-7700.

Recall 83V020000 started on /Date(414910800000-0500)/.

Summary: THE MANUFACTURER SUSPECTS THAT THE HARDWARE THAT ATTACHES THE SEAT TRACKS (THE STRIPS THAT THE SEAT SLIDES ON) TO THE FLOOR MAY BECOME LOOSE OR MAY FAIL TO HOLD THE SEAT IN PLACE DURING A COLLISION. THIS CONDITION IS DUE TO THE SUBSTITUTION OF AN INCORRECT WASHER DURING MANUFACTURE. THE VEHICLES MAY NOT COMPLY WITH THE STRENGTH REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD 207, "SEATING SYSTEMS".

Consequence: Not Defined

Remedy: THE DEALER WILL INSPECT AND INSTALL ADDITIONAL LARGER DIAMETER WASHERS ON THE BOLT ASSEMBLY.