1984 Chevrolet Corvette Review

Recall 07E088000 started on /Date(1193198400000-0400)/.

Summary: CERTAIN HONEYWELL FRAM RACING BRAND HP4 AND HP8 OIL FILTERS THAT WERE MANUFACTURED FROM MAY 25, 2006, THROUGH SEPTEMBER 14, 2007, AND SOLD FOR USE AS REPLACEMENT EQUIPMENT FOR VEHICLES LIST ABOVE. THE AFFECTED FILTERS ARE MARKED WITH A DATE CODE A61451 THROUGH A72571 SEQUENTIALLY. THE DATE CODE AND PART NUMBER APPEAR ON THE FILTER HOUSING. FRAM RACING HP4 AND HP8 OIL FILTERS NOT BEARING A DATE CODE IN THIS RANGE ARE NOT AFFECTED BY THIS RECALL. THE GASKET OF THE OIL FILTER BECOMES MORE PLIABLE UNDER HIGH TEMPERATURES AND PRESSURES.

Consequence: THIS CONDITION MAY CAUSE INADEQUATE SEALING AND LOSS OF ENGINE OIL, POSSIBLY RESULTING IN A FIRE.

Remedy: HONEYWELL WILL REPLACE THE AFFECTED OIL FILTERS FREE OF CHARGE. THE RECALL BEGAN DURING NOVEMBER 2007. OWNERS CAN CONTACT FRAM CUSTOMER SERVICE TOLL-FREE AT 1-800-890-2075.

Recall 83V081000 started on /Date(430632000000-0400)/.

Summary: THE INSULATION OF THE BATTERY CABLE, BECAUSE OF ITS POSITION, RUBS AGAINST SOME OF THE ENGINE WIRING COMPONENTS. ONCE THE INSULATION IS WORN THROUGH, THE BATTERY COULD RAPIDLY DISCHARGE.

Consequence: Not Defined

Remedy: DEALER WILL INSTALL A NEW ENGINE HARNESS RETAINER BRACKET, PROTECTIVE CONDUIT, CABLE CLIPS, A CABLE TIE STRAP AND WILL REPOSITION THE TERMINALS ON THE GROUND STUD ON ALL INVOLVED VEHICLES.

Recall 83V064000 started on /Date(426398400000-0400)/.

Summary: ATTACHING BOLTS WERE MISTAKENLY COATED WITH A SLIPPERY MATERIAL DURING PRODUCTION. THIS MATERIAL WILL ACT AS A LUBRICANT AND BOLTS MAY LOOSEN AND EVENTUALLY FALL OFF.

Consequence: Not Defined

Remedy: DEALER WILL INSTALL NEW CALIPER BRACKET BOLTS FREE OF CHARGE.

Recall 85V029000 started on /Date(480056400000-0500)/.

Summary: THE CRUISE CONTROL VACUUM SOLENOID VALVES MAY MALFUNCTION AT ANY TIME THE ENGINE IS RUNNING AND THE CRUISE CONTROL IS ENGAGED AND CAUSE UNEXPECTED ENGINE ACCELERATION. CONSEQUENCE OF DEFECT: LOSS OF ACCELERATOR CONTROL COULD RESULT IN A VEHICLE CRASH WITHOUT PRIOR WARNING.

Consequence: Not Defined

Remedy: INSTALL AND RELOCATE A NEW CRUISE CONTROL SERVO ASSEMBLY.

Recall 85V118000 started on /Date(496987200000-0400)/.

Summary: CARS MAY LOSE THE WIRE SNAP RINGS THAT HOLD THE DIFFERENTIAL CROSS SHAFT IN POSITION IN THE REAR AXLE DIFFERENTIAL CASE ASSEMBLY, ALLOWING THE SHAFT TO MOVE. CONSEQUENCE OF DEFECT: THE CROSS SHAFT MOVEMENT COULD CAUSE THE SHAFT TO CONTACT THE CARRIER OR PINION TEETH, POSSIBLY LOCKING UP THE REAR WHEELS AND RESULT IN A CRASH WITHOUT PRIOR WARNING.

Consequence: Not Defined

Remedy: INSTALL A REAR AXLE DIFFERENTIAL CROSS SHAFT RETAINING KIT.

Recall 91V143000 started on /Date(683956800000-0400)/.

Summary: UNDER CERTAIN VEHICLE OPERATIONS AND OCCUPANT USAGE CONDITIONS, THE SAFETY BELTS CAN LOCKUP OR JAM IN THE SAFETY BELT RETRACTOR.

Consequence: IF LOCKUP OCCURS, IT IS IMPOSSIBLE TO PULL BELT OUT OFTHE RETRACTOR. THE OCCUPANT OF A SEAT WITH AN UNUSABLE SAFETY BELT ISSUBJECT TO INCREASED RISK OF INJURY OR DEATH IN THE EVENT OF A SUDDEN STOP ORACCIDENT.

Remedy: REPLACE THE SAFETY BELTS IF THE LOCKUP OCCURS.