1990 Jeep Cherokee Review

Recall 06E026000 started on /Date(1143090000000-0500)/.

Summary: CERTAIN PRO-A MOTORS CORNER LAMPS, TURN SIGNALS, AND HEADLIGHTS SOLD AS REPLACEMENT LAMPS FOR USE ON CERTAIN PASSENGER VEHICLES LISTED ABOVE. SOME COMBINATION LAMPS THAT ARE NOT EQUIPPED WITH AMBER SIDE REFLECTORS FAIL TO CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT.

Consequence: WITHOUT THE AMBER REFLECTORS, THE VEHICLE WILL BE POORLY ILLUMINATED, POSSIBLY RESULTING IN A VEHICLE CRASH WITHOUT WARNING.

Remedy: PRO-A MOTORS WILL NOTIFY OWNERS AND OFFER TO REPURCHASE THE LAMPS. THE RECALL BEGAN ON APRIL 3, 2006. OWNERS MAY CONTACT PRO-A MOTORS AT 323-838-2988.

Recall 09E012000 started on /Date(1239076800000-0400)/.

Summary: SABERSPORT IS RECALLING 16,270 COMBINATION CORNER AND BUMPER LAMP ASSEMBLIES OF VARIOUS PART NUMBERS SOLD FOR USE AS AFTERMARKET EQUIPMENT FOR VARIOUS PASSENGER VEHICLES. THESE HEADLAMPS FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." THESE LAMPS DO NOT CONTAIN THE REQUIRED AMBER SIDE REFLECTORS.

Consequence: DECREASED LIGHTING VISIBILITY MAY RESULT IN A VEHICLE CRASH.

Remedy: SABERSPORT WILL NOTIFY OWNERS AND OFFER A FULL REFUND FOR THE NONCOMPLIANT COMBINATION LAMPS. THE SAFETY RECALL BEGAN ON MAY 11, 2009. OWNERS MAY CONTACT SABERSPORT AT 1-909-598-7589.

Recall 09E025000 started on /Date(1242014400000-0400)/.

Summary: DOPE, INC. IS RECALLING 42,540 COMBINATION CORNER AND BUMPER LAMP ASSEMBLIES OF VARIOUS PART NUMBERS SOLD FOR USE AS AFTERMARKET EQUIPMENT FOR VARIOUS PASSENGER VEHICLES. THESE HEADLAMPS FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." THESE LAMPS DO NOT CONTAIN THE REQUIRED AMBER SIDE REFLECTORS.

Consequence: DECREASED LIGHTING VISIBILITY MAY RESULT IN A VEHICLE CRASH.

Remedy: DOPE, INC. WILL NOTIFY OWNERS AND OFFER A FULL REFUND FOR THE NONCOMPLIANT COMBINATION LAMPS. THE SAFETY RECALL BEGAN ON JULY 28, 2009. OWNERS MAY CONTACT DOPE, INC. AT 1-626-272-1798.

Recall 91V063000 started on /Date(671688000000-0400)/.

Summary: IMPROPER INSERTION/CRIMPING OF THE HOSE-TO-END FITTINGS OF THE HIGH PRESSURE HOSE ON THE ANTI-LOCK BRAKE SYSTEM CAN CAUSE DETACHMENT OF THE HOSE FROM THE ABS SYSTEM, AND DISCHARGE OF HYDRAULIC FLUID.

Consequence: DETACHMENT OF THE HOSE FROM THE ABS SYSTEM CAUSES THELOSS OF THE ABS FUNCTION AND HYDRAULIC BRAKE ASSIST, LEAVING ONLY MANUAL BRAKESAND DECREASING STOPPING ABILITY, WHICH COULD RESULT IN AN ACCIDENT. DISCHARGE OFHYDRAULIC FLUID IN THE AREA OF THE HOT EXHAUST SYSTEM COULD RESULT IN AN ENGINECOMPARTMENT FIRE.

Remedy: REPLACE THE ABS HIGH PRESSURE HOSE.

Recall 90V177000 started on /Date(654840000000-0400)/.

Summary: MALFUNCTION OF FUEL INJECTION SYSTEM THROTTLE POSTITION SENSOR COULD CAUSE INTERMITTENT HIGH ENGINE IDLE SPEED IMMEDIATELY AFTER STARTING ENGINE.

Consequence: HIGH ENGINE IDLE WHEN CAR IS FIRST PLACED IN GEAR COULDRESULT IN UNEXPECTED ACCELERATION.

Remedy: REPLACE THROTTLE POSITION SENSORS WITH SENSORS THAT WOULD SEND CORRECT SIGNALS TO THE FUEL INJECTION SYSTEM.

Recall 91V003000 started on /Date(686376000000-0400)/.

Summary: THERE MAY BE HYDRAULIC FLUID CONTAMINATION FROM CONDENSATION FORMATION THAT CAN PLUG THE ABS BRAKE BOOSTER PUMP FILTER; STRESS CORROSION OF THE MASTER CYLINDER SNAP RING HAS BEEN TRACED TO CHLORINE LEAKING FROM THE LOW PRESSURE HYDRAULIC HOSE WHICH MAY CAUSE IT TO BREAK; FRONT BRAKE HOSE TO TIRE INTERFERENCE WHICH MAY CAUSE FAILURE OF THE BRAKE HOSE.

Consequence: CONTAMINATION OF THE HYDRAULIC FLUID CAN CAUSEMALFUNCTIONING OF THE ANTI-LOCK BRAKE SYSTEM; LOW PRESSURE HOSE LEAKAGE CAUSESLOSS OF BRAKE FLUID AND ALSO RESULTS IN CORROSION AND FAILURE OF THE MASTERCYLINDER SNAP RING, RESULTING COMPLETE BRAKE FAILURE; FAILURE OF THE FRONT BRAKEHOSE DUE TO HOSE TO TIRE INTERFERENCE WILL CAUSE FAILURE OF ONE HALF OF THEBRAKE SYSTEM RESULTING IN A LONGER STOPPING DISTANCE THAN EXPECTED.

Remedy: REPLACE ABS LOW PRESSURE HOSE; REBUILD MASTER BRAKE CYLINDER; INSPECT, SERVICE INTERFERENCE PROBLEMS, AND REPLACE FRONT BRAKE HOSE AS NECESSARY.

Recall 96V260000 started on /Date(851662800000-0500)/.

Summary: VEHICLE DESCRIPTION: VEHICLES EQUIPPED WITH ANTILOCK BRAKE SYSTEM (ABS). THE ANTILOCK BRAKE SYSTEM (ABS) HYDRAULIC CONTROL UNIT CAN EXPERIENCE EXCESSIVE BRAKE ACTUATOR PISTON SEAL WEAR WHICH COULD CAUSE PUMP-MOTOR DETERIORATION.

Consequence: IF THIS OCCURS, THE ABS FUNCTION WOULD BE LOSE AND REDUCED POWER ASSIST WOULD BE EXPERIENCED DURING VEHICLE BRAKING. THE INSTRUMENT PANEL WARNING LIGHTS WILL SIGNAL SYSTEM IMPAIRMENT AND THE BASE MANUAL BRAKES WILL REMAIN FUNCTIONAL.

Remedy: DEALERS WILL TEST THE VEHICLE'S ABS AND REPAIR AS NECESSARY. THE WARRANTY ON ALL ABS COMPONENTS WILL BE EXTENDED TO 10 YEARS OR 100,000 MILES (EXCEPT FOR THE BRAKE ACTUATOR PISTON ASSEMBLY AND THE PUMP-MOTOR ASSEMBLY WHICH WILL HAVE A LIFETIME COVERAGE). OWNERS WILL BE REIMBURSED FOR PREVIOUS ABS COMPONENT REPAIR COSTS.

Recall 97I002000 started on /Date(862545600000-0400)/.

Summary: VEHICLE DESCRIPTION: MULTIPURPOSE PASSENGER VEHICLES EQUIPPED WITH AUTOMATIC TRANSMISSIONS. THIS IS NOT A SAFETY RECALL IN ACCORDANCE WITH FEDERAL REGULATION 573. HOWEVER, IT IS DEEMED A SAFETY IMPROVEMENT CAMPAIGN BY THE AGENCY. DRIVERS CAN MISTAKENLY STEP ON THE ACCELERATOR PEDAL WHEN THEY INTEND TO STEP ON THE BRAKE PEDAL.

Consequence: PEDAL MISAPPLICATION BY A DRIVER CAN CAUSE UNINTENDED ACCELERATION.

Remedy: DEALERS WILL INSTALL A SHIFT INTERLOCK ON THE AUTOMATIC TRANSMISSION OF THESE VEHICLES.

Recall 98V005000 started on /Date(884581200000-0500)/.

Summary: VEHICLE DESCRIPTION: PASSENGER AND MULTI-PURPOSE VEHICLES ORIGINALLY SOLD OR CURRENTLY REGISTERED IN THE STATES OF CONNECTICUT, ILLINOIS, INDIANA, MAINE, MARYLAND, MASSACHUSETTS, MICHIGAN, NEW HAMPSHIRE, NEW JERSEY, NEW YORK, OHIO, PENNSYLVANIA, RHODE ISLAND, VERMONT, OR WISCONSIN, AND THE DISTRICT OF COLUMBIA. THE FRONT DISC BRAKE ROTORS CAN EXPERIENCE SEVERE CORROSION IF OPERATED FOR AN EXTENSIVE PERIOD IN THE "SALT BELT." IF THE ROTORS ARE NOT REPLACED, THE CORROSION CAN EVENTUALLY COMPROMISE THE STRUCTURAL INTEGRITY OF THE STAMPED STEEL CENTER HUB SECTION OF THE ROTOR.

Consequence: THE REDUCED STRENGTH CAN ALLOW THE CAST IRON WEAR SURFACE TO SEPARATE FROM THE HUB, REDUCING THE BRAKE EFFECTIVENESS OF THE VEHICLE.

Remedy: DEALERS WILL REPLACE THESE ROTORS WITH ROTORS THAT ARE COATED WITH A CORROSION PROTECTION.