1990 Jeep Wagoneer Review
1990 Jeep Wagoneer is a Sport Utility 4-dr style car measuring 165.30 in length and 63.30 in height. Made in United States, 1990 Jeep Wagoneer has 1 trim priced by the manufacturer at 24,913 with just total of 5 recalls in the past 1990 Jeep Wagoneer. It’s seating 5 people with 4 doors and a rank size of 20.20 gallon. The engine is 4.0L L6 OHV 12V and uses 16 of gasoline in the city and 16 on highways.
Vin Numbers
- 1J4FN78L1LL275909
- 1J4FN78L5LL174260
- 1J4FN78L7LL164992
- 1J4FN78L7LL248486
- 1J4FN78L8LL259822
- 1J4FN78L9LL282171
- 1J4FN78LXLL145370
- 1J4FN78L5LL165073
- 1J4FN78LXLL104589
- 1J4FN78L6LL251802
- 1J4FN78L1LL243834
Safety & Recalls
Recall 91V063000 started on /Date(671688000000-0400)/.
Summary: IMPROPER INSERTION/CRIMPING OF THE HOSE-TO-END FITTINGS OF THE HIGH PRESSURE HOSE ON THE ANTI-LOCK BRAKE SYSTEM CAN CAUSE DETACHMENT OF THE HOSE FROM THE ABS SYSTEM, AND DISCHARGE OF HYDRAULIC FLUID.
Consequence: DETACHMENT OF THE HOSE FROM THE ABS SYSTEM CAUSES THELOSS OF THE ABS FUNCTION AND HYDRAULIC BRAKE ASSIST, LEAVING ONLY MANUAL BRAKESAND DECREASING STOPPING ABILITY, WHICH COULD RESULT IN AN ACCIDENT. DISCHARGE OFHYDRAULIC FLUID IN THE AREA OF THE HOT EXHAUST SYSTEM COULD RESULT IN AN ENGINECOMPARTMENT FIRE.
Remedy: REPLACE THE ABS HIGH PRESSURE HOSE.
Recall 90V177000 started on /Date(654840000000-0400)/.
Summary: MALFUNCTION OF FUEL INJECTION SYSTEM THROTTLE POSTITION SENSOR COULD CAUSE INTERMITTENT HIGH ENGINE IDLE SPEED IMMEDIATELY AFTER STARTING ENGINE.
Consequence: HIGH ENGINE IDLE WHEN CAR IS FIRST PLACED IN GEAR COULDRESULT IN UNEXPECTED ACCELERATION.
Remedy: REPLACE THROTTLE POSITION SENSORS WITH SENSORS THAT WOULD SEND CORRECT SIGNALS TO THE FUEL INJECTION SYSTEM.
Recall 91V003000 started on /Date(686376000000-0400)/.
Summary: THERE MAY BE HYDRAULIC FLUID CONTAMINATION FROM CONDENSATION FORMATION THAT CAN PLUG THE ABS BRAKE BOOSTER PUMP FILTER; STRESS CORROSION OF THE MASTER CYLINDER SNAP RING HAS BEEN TRACED TO CHLORINE LEAKING FROM THE LOW PRESSURE HYDRAULIC HOSE WHICH MAY CAUSE IT TO BREAK; FRONT BRAKE HOSE TO TIRE INTERFERENCE WHICH MAY CAUSE FAILURE OF THE BRAKE HOSE.
Consequence: CONTAMINATION OF THE HYDRAULIC FLUID CAN CAUSEMALFUNCTIONING OF THE ANTI-LOCK BRAKE SYSTEM; LOW PRESSURE HOSE LEAKAGE CAUSESLOSS OF BRAKE FLUID AND ALSO RESULTS IN CORROSION AND FAILURE OF THE MASTERCYLINDER SNAP RING, RESULTING COMPLETE BRAKE FAILURE; FAILURE OF THE FRONT BRAKEHOSE DUE TO HOSE TO TIRE INTERFERENCE WILL CAUSE FAILURE OF ONE HALF OF THEBRAKE SYSTEM RESULTING IN A LONGER STOPPING DISTANCE THAN EXPECTED.
Remedy: REPLACE ABS LOW PRESSURE HOSE; REBUILD MASTER BRAKE CYLINDER; INSPECT, SERVICE INTERFERENCE PROBLEMS, AND REPLACE FRONT BRAKE HOSE AS NECESSARY.
Recall 96V260000 started on /Date(851662800000-0500)/.
Summary: VEHICLE DESCRIPTION: VEHICLES EQUIPPED WITH ANTILOCK BRAKE SYSTEM (ABS). THE ANTILOCK BRAKE SYSTEM (ABS) HYDRAULIC CONTROL UNIT CAN EXPERIENCE EXCESSIVE BRAKE ACTUATOR PISTON SEAL WEAR WHICH COULD CAUSE PUMP-MOTOR DETERIORATION.
Consequence: IF THIS OCCURS, THE ABS FUNCTION WOULD BE LOSE AND REDUCED POWER ASSIST WOULD BE EXPERIENCED DURING VEHICLE BRAKING. THE INSTRUMENT PANEL WARNING LIGHTS WILL SIGNAL SYSTEM IMPAIRMENT AND THE BASE MANUAL BRAKES WILL REMAIN FUNCTIONAL.
Remedy: DEALERS WILL TEST THE VEHICLE'S ABS AND REPAIR AS NECESSARY. THE WARRANTY ON ALL ABS COMPONENTS WILL BE EXTENDED TO 10 YEARS OR 100,000 MILES (EXCEPT FOR THE BRAKE ACTUATOR PISTON ASSEMBLY AND THE PUMP-MOTOR ASSEMBLY WHICH WILL HAVE A LIFETIME COVERAGE). OWNERS WILL BE REIMBURSED FOR PREVIOUS ABS COMPONENT REPAIR COSTS.
Recall 98V005000 started on /Date(884581200000-0500)/.
Summary: VEHICLE DESCRIPTION: PASSENGER AND MULTI-PURPOSE VEHICLES ORIGINALLY SOLD OR CURRENTLY REGISTERED IN THE STATES OF CONNECTICUT, ILLINOIS, INDIANA, MAINE, MARYLAND, MASSACHUSETTS, MICHIGAN, NEW HAMPSHIRE, NEW JERSEY, NEW YORK, OHIO, PENNSYLVANIA, RHODE ISLAND, VERMONT, OR WISCONSIN, AND THE DISTRICT OF COLUMBIA. THE FRONT DISC BRAKE ROTORS CAN EXPERIENCE SEVERE CORROSION IF OPERATED FOR AN EXTENSIVE PERIOD IN THE "SALT BELT." IF THE ROTORS ARE NOT REPLACED, THE CORROSION CAN EVENTUALLY COMPROMISE THE STRUCTURAL INTEGRITY OF THE STAMPED STEEL CENTER HUB SECTION OF THE ROTOR.
Consequence: THE REDUCED STRENGTH CAN ALLOW THE CAST IRON WEAR SURFACE TO SEPARATE FROM THE HUB, REDUCING THE BRAKE EFFECTIVENESS OF THE VEHICLE.
Remedy: DEALERS WILL REPLACE THESE ROTORS WITH ROTORS THAT ARE COATED WITH A CORROSION PROTECTION.