1990 Mitsubishi Eclipse Review
1990 Mitsubishi Eclipse is a Hatchback 2-dr style car measuring 170.50 in length and 51.40 in height. Made in United States, 1990 Mitsubishi Eclipse has 5 trims priced by the manufacturer at 14,639 with just total of 7 recalls in the past 1990 Mitsubishi Eclipse. It’s seating 4 people with 2 doors and a rank size of 15.90 gallon. The engine is 2.0L L4 DOHC 16V TURBO and uses 22 of gasoline in the city and 22 on highways.
Vin Numbers
- 4A3CS44U0LE033595
- 4A3CS44U3LE095511
- 4A3CS44U5LE060548
- 4A3CS44U7LE106140
- 4A3CS44UXLE115477
- 4A3CS44UXLE055412
- 4A3CS44U9LE080138
- 4A3CS44U1LE130398
- 4A3CS44U0LE110983
- 4A3CS44U6LE048246
- 4A3CS44U5LE074384
Safety & Recalls
Recall 06E065000 started on /Date(1153108800000-0400)/.
Summary: CERTAIN AJ MOTORSPORT COMBINATION LAMPS SOLD AS REPLACEMENT LAMPS FOR USE ON THE ABOVE LISTED PASSENGER VEHICLES. COMBINATION LAMPS NOT EQUIPPED WITH AMBER SIDE REFLECTORS FAIL TO CONFORM WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT.
Consequence: LACK OF AMBER SIDE REFLECTORS IN THE LAMPS WILL DECREASE LIGHTING VISIBILITY TO OTHER DRIVERS AND MAY POSSIBLY RESULT IN A VEHICLE CRASH.
Remedy: AJ MOTORSPORT WILL NOTIFY OWNERS AND OFFER REIMBURSEMENT FOR THE LAMPS. THE RECALL BEGAN ON JULY 31, 2006. OWNERS MAY CONTACT AJ MOTORSPORT AT 626-618-2026.
Recall 09E012000 started on /Date(1239076800000-0400)/.
Summary: SABERSPORT IS RECALLING 16,270 COMBINATION CORNER AND BUMPER LAMP ASSEMBLIES OF VARIOUS PART NUMBERS SOLD FOR USE AS AFTERMARKET EQUIPMENT FOR VARIOUS PASSENGER VEHICLES. THESE HEADLAMPS FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." THESE LAMPS DO NOT CONTAIN THE REQUIRED AMBER SIDE REFLECTORS.
Consequence: DECREASED LIGHTING VISIBILITY MAY RESULT IN A VEHICLE CRASH.
Remedy: SABERSPORT WILL NOTIFY OWNERS AND OFFER A FULL REFUND FOR THE NONCOMPLIANT COMBINATION LAMPS. THE SAFETY RECALL BEGAN ON MAY 11, 2009. OWNERS MAY CONTACT SABERSPORT AT 1-909-598-7589.
Recall 90V056002 started on /Date(637995600000-0500)/.
Summary: OPERATION OF SUNROOF IN "NON-STANDARD" MANNER MAY CAUSE MALE HINGE DISENGAGEMENT FROM THE ROOF HINGE RECEIVER.
Consequence: THE SUNROOF GLASS COULD DETACH FROM THE ROOF AND RESULT IN INJURY TO OCCUPANTS OR PERSONS IN THE VICINITY, ESPECIALLY IF THIS OCCURS WHILE THE VEHICLE IS IN MOTION.
Remedy: REPLACE MALE HINGE WITH A MODIFIED VERSION TO INCREASE ROOF HINGE RECEIVER RETENTION ABILITY.
Recall 90V106002 started on /Date(644212800000-0400)/.
Summary: DILUTED PRIMER MAY HAVE BEEN USED ON THE WINDSHIELD OPENING FLANGES PRIOR TO WINDSHIELD GLASS INSTALLATION WHICH WOULD NOT PROVIDE THE RETENTION REQUIRED BY FMVSS 212.
Consequence: WINDSHIELDS WOULD NOT PREVENT EJECTION OF VEHICLEOCCUPANTS DURING A VEHICLE CRASH, WHICH CAUSES SERIOUS INJURIES AND FATALITIES.
Remedy: REPLACE WINDSHIELDS, ASSOCIATED PARTS, AND PRIMER.
Recall 89V128000 started on /Date(617860800000-0400)/.
Summary: WIRING HARNESS FOR THE HEADLAMPS MAY BREAK DUE TO THE STRESS CREATED BY THE HEADLAMP POP UP DEVICES.
Consequence: BREAKAGE OF THE WIRING HARNESS CAUSES LOSS OFHEADLAMP ILLUMINATION WHICH COULD HAVE A POTENTIAL FOR AN ACCIDENT.
Remedy: HEADLAMP WIRING HARNESS ROUTING WILL BE MODIFIED AND DAMAGED WIRES REPAIRED.
Recall 95V103004 started on /Date(801288000000-0400)/.
Summary: THE FRONT SAFETY BELT BUCKLE RELEASE BUTTONS CAN BREAK. THESE RED PLASTIC RELEASE BUTTONS ARE MARKED "PRESS." IF A BUTTON BREAKS, PIECES CAN FALL INTO THE BUCKLE ASSEMBLY CAUSING THE BUCKLE TO OPERATE IMPROPERLY.
Consequence: THE SAFETY BELTS WOULD NOT PROVIDE ADEQUATE PROTECTION TO AN OCCUPANT IN A VEHICLE CRASH.
Remedy: OWNERS SHOULD PROMPTLY CHECK THE CONDITION AND OPERATION OF BOTH FRONT SAFETY BELT BUCKLES AND CAREFULLY INSPECT THE RED RELEASE BUTTON FOR ANY BREAKS OR CRACKS. THEY SHOULD ENSURE THAT BOTH BUCKLES ARE OPERATING PROPERLY BY INSERTING EACH LATCH PLATE INTO ITS BUCKLE, TUGGING ON THE BELT TO MAKE SURE THE LATCH IS SECURELY LOCKED, AND THEN PRESSING THE RELEASE BUTTON. THE LATCH PLATE SHOULD POP OUT OF THE BUCKLE WHEN THE BUTTON IS PRESSED. IF EITHER RELEASE BUTTON SHOWS A SIGN OF BREAKING OR CRACKING OR IF EITHER BUCKLE FAILS TO OPERATE PROPERLY, OWNERS SHOULD PROMPTLY CONTACT THEIR AUTHORIZED DEALER TO SCHEDULE AN APPOINTMENT TO HAVE THE BUCKLE REPLACED OR REPAIRED, FREE OF CHARGE. THE MANUFACTURER IS DEVELOPING A REMEDY DESIGNED TO PREVENT FAILURE OF THE BUTTONS THAT ARE NOT CURRENTLY BROKEN.
Recall 98V069001 started on /Date(890888400000-0500)/.
Summary: VEHICLE DESCRIPTION: PASSENGER VEHICLES. LOCKUP OF THE TRANSFER CASE CAN OCCUR DUE TO INSUFFICIENT LUBRICATION.
Consequence: THIS CONDITION CAN CAUSE A LOSS OF VEHICLE CONTROL, INCREASING THE RISK OF A CRASH.
Remedy: DEALERS WILL INSPECT THE VEHICLES FOR ADEQUACY OF THE TRANSFER CASE OIL VOLUME, TRANSFER CASE OIL LEAKAGE, AND OPERATIONAL DEGRADATION OF THE TRANSFER CASE MECHANISM. IF OIL VOLUME IS INSUFFICIENT, THE APPROPRIATE AMOUNT OF OIL WILL BE ADDED. IF THERE IS TRANSFER CASE OIL LEAKAGE, AFFECTED COMPONENTS WILL BE REPLACED. IF THE TRANSFER CASE SHOWS OPERATIONAL DEGRADATION, THE TRANSFER CASE WILL BE REPLACED.