1997 Nissan Altima Review
1997 Nissan Altima is a Sedan 4-dr style car measuring 180.50 in length and 55.90 in height. Made in United States, 1997 Nissan Altima has 3 trims priced by the manufacturer at 20,899 with just total of 3 recalls in the past 1997 Nissan Altima. It’s seating 5 people with 4 doors and a rank size of 15.90 gallon. The engine is 2.4L L4 DOHC 16V and uses 21 - 24 of gasoline in the city and 21 - 24 on highways.
Vin Numbers
- 1N4BU31D0VC212098
Safety & Recalls
Recall 06E026000 started on /Date(1143090000000-0500)/.
Summary: CERTAIN PRO-A MOTORS CORNER LAMPS, TURN SIGNALS, AND HEADLIGHTS SOLD AS REPLACEMENT LAMPS FOR USE ON CERTAIN PASSENGER VEHICLES LISTED ABOVE. SOME COMBINATION LAMPS THAT ARE NOT EQUIPPED WITH AMBER SIDE REFLECTORS FAIL TO CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT.
Consequence: WITHOUT THE AMBER REFLECTORS, THE VEHICLE WILL BE POORLY ILLUMINATED, POSSIBLY RESULTING IN A VEHICLE CRASH WITHOUT WARNING.
Remedy: PRO-A MOTORS WILL NOTIFY OWNERS AND OFFER TO REPURCHASE THE LAMPS. THE RECALL BEGAN ON APRIL 3, 2006. OWNERS MAY CONTACT PRO-A MOTORS AT 323-838-2988.
Recall 10E002000 started on /Date(1265864400000-0500)/.
Summary: RIDE CONTROL IS RECALLING CERTAIN FRONT STRUT MOUNTS BRANDED AS GABRIEL RIDE CONTROL OR ARVINMERITOR, P/NOS. 142435, 142193, 142305, 142303, SOLD AS REPLACEMENT EQUIPMENT FOR THE VEHICLES LISTED ABOVE. THE AFFECTED FRONT STRUT MOUNTS DID NOT CONTAIN A WELD JOINT BETWEEN THE BEARING HOUSING AND THE RATE PLATE.
Consequence: THE ABSENCE OF THE WELD CAN ALLOW THE STRUT TO COME OUT OF ITS MOUNTING POSITION UNDER CERTAIN EXTREME DRIVING CONDITIONS WHICH COULD CAUSE DAMAGE TO SURROUNDING VEHICLE COMPONENTS INCREASING THE RISK OF A CRASH.
Remedy: RIDE CONTROL WILL NOTIFY OWNERS OF RECORD AND REPLACE THE AFFECTED PARTS FREE OF CHARGE. THE SAFETY RECALL BEGAN ON MARCH 15, 2010. OWNERS MAY CONTACT RIDE CONTROL AT 1-248-458-1396.
Recall 96V185000 started on /Date(844920000000-0400)/.
Summary: CERTAIN BUCKLE ASSEMBLIES WERE PRODUCED WITH A "BUCKLE BASE" THAT WAS IMPROPERLY HEAT TREATED. THIS CAN CAUSE THE "BUCKLE BASE" TO BE BRITTLE FAILING TO COMPLY TO FMVSS NO. 209, "SEAT BELT ASSEMBLIES."
Consequence: IN THE EVENT OF A COLLISION, THESE SEAT BELTS MAY NOT RESTRAIN AN OCCUPANT INCREASING THE RISK OF INJURY.
Remedy: DEALERS WILL INSPECT THE BUCKLE ASSEMBLIES AND REPLACE THEM IF NECESSARY.