1990 Pontiac 6000 Review
1990 Pontiac 6000 is a Sedan 4-dr style car measuring 188.90 in length and 53.70 in height. Made in United States, 1990 Pontiac 6000 has 2 trims priced by the manufacturer at 13,079 with just total of 2 recalls in the past 1990 Pontiac 6000. It’s seating 6 people with 4 doors and a rank size of 15.70 gallon. The engine is 3.1L V6 OHV 12V and uses 23 of gasoline in the city and 23 on highways.
Vin Numbers
- 1G2AF54R4L6251666
- 1G2AF54T6L6209477
- 1G2AF54T7L6248756
- 1G2AF54T9L6265879
- 1G2AF54T2L6205443
- 1G2AF54R4L6247066
- 1G2AF54T6L6247033
- 1G2AF54R3L6229626
- 1G2AF54T5L6216467
- 1G2AF54T3L6214491
- 1G2AF54T0L6256911
- 1G2AF54T4L6238315
- 1G2AF54T8L6207536
- 1G2AF54R6L6207524
- 1G2AF54T7L6202716
- 1G2AF54T0L6221141
- 1G2AF54R4L6218019
- 1G2AF54T0L6263101
- 1G2AF54R6L6205921
- 1G2AF54R3L6256390
- 1G2AF54T2L6215826
- 1G2AF54T6L6214498
- 1G2AF54R7L6236806
- 1G2AF54T4L6257897
- 1G2AF54T7L6200593
Safety & Recalls
Recall 92V124000 started on /Date(715320000000-0400)/.
Summary: THE POWER SEAT OR RECLINER WIRING HARNESS CAN BE PINCHED OR CAN CHAFE ON THE SEAT FRAME OR SPRING SUPPORT ROD, WEARING THROUGH THE WIRE INSULATION AND CAUSING AN ELECTRICAL SHORT.
Consequence: THE HIGH CURRENT CAUSED BY THE ELECTRICAL SHORT WELDS THECIRCUIT BREAKER ELEMENTS TOGETHER IN THE CLOSED POSITION, LEAVING THE CIRCUITUNPROTECTED AND GENERATING SUFFICIENT HEAT TO BURN THE WIRE INSULATION ANDIGNITE THE SEAT CUSHION MATERIAL.
Remedy: REPAIR ANY ABRADED WIRING AND REROUTE THE WIRING HARNESS USING A WIRING HARNESS CLIP.
Recall 95V173000 started on /Date(811137600000-0400)/.
Summary: THESE VEHICLES WERE ASSEMBLED WITH REAR OUTBOARD SAFETY BELT ANCHORAGES THAT MAY NOT WITHSTAND THE REQUIRED LOAD. THIS DOES NOT COMPLY WITH FMVSS NO.210, "SEAT BELT ASSEMBLY ANCHORAGES."
Consequence: CONSEQUENCE OF NON-COMPLIANCE: IN A COLLISON, STRESS CAN CAUSE THE ATTACHMENT METAL TO TEAR AND ALLOW THE ANCHORAGE TO SEPARATE FROM THE BODY OF THE VEHICLE. THE SAFETY BELT MAY NOT PROTECT AN OCCUPANT IN THE EVENT OF A VEHICLE CRASH.
Remedy: DEALERS WILL REPLACE THE EXISTING ANCHOR BOLTS WITH A NEW SHOULDER BOLT AND THREAD LOCKING ADHESIVE. ADDITIONALLY, NOISE CONTROL PATCHES WILL BE APPLIED AT EACH ANCHORAGE.