1991 GMC Safari Review

Recall 06E043000 started on /Date(1148011200000-0400)/.

Summary: CERTAIN REPLACEMENT FUEL FILTERS, FRAM BRAND NAME P/N G3727, WITH DATE CODES X52911 THROUGH X60801 SEQUENTIALLY OR X600141 AND A MEXICO COUNTRY OR ORIGIN MARKING ON THE FUEL FILTER HOUSING MANUFACTURED FROM OCTOBER 18, 2005, THROUGH MARCH 21, 2006, SOLD FOR USE ON THE VEHICLES LISTED ABOVE AND ON CERTAIN SCHOOL BUSES. (TO SEE THE SCHOOL BUS ENGINE SIZES, CLICK ON "DOCUMENT SEARCH" AND THEN "BUS APPLICATIONS"). THE CONNECTOR ON THE FUEL FILTER WAS NOT MANUFACTURED TO HONEYWELL'S SPECIFICATION. AS A RESULT, THE O-RING MAY NOT SEAT CORRECTLY ON THE FUEL LINE.

Consequence: THIS CONDITION MAY CAUSE AN INADEQUATE SEAL AT THE CONNECTION, POTENTIALLY LEADING TO A FUEL LEAK. IN THE PRESENCE OF AN IGNITION SOURCE, A FIRE COULD OCCUR.

Remedy: HONEYWELL WILL NOTIFY OWNERS AND REPLACE THE FUEL FILTERS FREE OF CHARGE. THE RECALL BEGAN ON OCTOBER 18, 2006. OWNERS MAY CONTACT FRAM CUSTOMER SERVICE AT 1-800-890-2075 (OPTION 1).

Recall 91V164000 started on /Date(685339200000-0400)/.

Summary: SEAT BELT ANCHORAGE BAR FOR REAR SOFA FAILED TO SUSTAIN LOADS REQUIRED BY FMVSS 210.

Consequence: VEHICLES WOULD NOT COMPLY WITH FMVSS 210.

Remedy: REPLACE NONCOMPLYING SOFA BAR WITH BAR THAT MEETS REQUIREMENTS.

Recall 93V119000 started on /Date(744264000000-0400)/.

Summary: SEVERE CORROSION DUE TO ROAD SALT AT THE JOINT OF THE STAMPED STEEL CENTER SECTION AND THE CAST OUTER SECTION CAN CAUSE THE SECTIONS TO SEPARATE.

Consequence: SEPARATION OF THE ROTOR SECTIONS CAN CAUSE LOSS OFBRAKING ABILITY IN THE AFFECTED WHEEL. THIS COULD RESULT IN INCREASED STOPPINGDISTANCE AND/OR LOSS OF VEHICLE CONTROL AND AN ACCIDENT.

Remedy: REPLACE THE FRONT BRAKE ROTORS WITH NEW ROTORS WITH A CORROSION PROTECTION COATING. HOWEVER, IF REPLACEMENT OF BRAKE LININGS ARE NECESSARY, IT WILL BE DONE AT OWNER'S EXPENSE SINCE BRAKE LININGS ARE NORMAL MAINTENANCE ITEMS.

Recall 93V187000 started on /Date(753426000000-0500)/.

Summary: THE RECLINER MECHANISM AND THE SEAT FRAME MAY HAVE FOAM AND/OR VINYL BETWEEN THEM, CREATING A "SOFT" JOINT. THIS "SOFT" JOINT RESULTS IN LOWER THAN SPECIFIED BOLT TORQUE WHICH LEADS TO JOINT LOOSENESS, CAUSING BOLT FATIGUE AND EVENTUAL BOLT FAILURE.

Consequence: IF BOLT FAILURE OCCURS TO THE DRIVER'S SEAT, IT WOULDALLOW THE SEAT BACK TO SUDDENLY RECLINE, AND COULD RESULT IN LOSS OF VEHICLECONTROL AND A VEHICLE CRASH WITHOUT PRIOR WARNING.

Remedy: DEALERS WILL REMOVE THE FOAM AND/OR VINYL FROM BETWEEN THE RECLINER MECHANISM AND THE SEAT FRAME "SOFT" JOINT AND REPLACE THE RECLINER BOLTS.