1991 Infiniti Q45 Review
1991 Infiniti Q45 is a Sedan 4-dr style car measuring 199.80 in length and 56.30 in height. Made in Japan, 1991 Infiniti Q45 has 2 trims priced by the manufacturer at 42,900 with just total of 2 recalls in the past 1991 Infiniti Q45. It’s seating 5 people with 4 doors and a rank size of 22.50 gallon. The engine is 4.5L V8 DOHC 32V and uses 16 of gasoline in the city and 16 on highways.
Vin Numbers
- JNKNG01C0MM107640
- JNKNG01C1MM106321
- JNKNG01C7MM100605
- JNKNG01C9MM116112
- JNKNG01C4MM111593
- JNKNG01C8MM111757
- JNKNG01C2MM104349
- JNKNG01C8MM107515
Safety & Recalls
Recall 95V103002 started on /Date(801288000000-0400)/.
Summary: THE FRONT SAFETY BELT BUCKLE RELEASE BUTTONS CAN BREAK. THESE RED PLASTIC RELEASE BUTTONS ARE MARKED "PRESS." IF A BUTTON BREAKS, PIECES CAN FALL INTO THE BUCKLE ASSEMBLY CAUSING THE BUCKLE TO OPERATE IMPROPERLY.
Consequence: THE SAFETY BELTS WOULD NOT PROVIDE ADEQUATE PROTECTION TO AN OCCUPANT IN A VEHICLE CRASH.
Remedy: OWNERS SHOULD PROMPTLY CHECK THE CONDITION AND OPERATION OF BOTH FRONT SAFETY BELT BUCKLES AND CAREFULLY INSPECT THE RED RELEASE BUTTON FOR ANY BREAKS OR CRACKS. THEY SHOULD ENSURE THAT BOTH BUCKLES ARE OPERATING PROPERLY BY INSERTING EACH LATCH PLATE INTO ITS BUCKLE, TUGGING ON THE BELT TO MAKE SURE THE LATCH IS SECURELY LOCKED, AND THEN PRESSING THE RELEASE BUTTON. THE LATCH PLATE SHOULD POP OUT OF THE BUCKLE WHEN THE BUTTON IS PRESSED. IF EITHER RELEASE BUTTON SHOWS A SIGN OF BREAKING OR CRACKING OR IF EITHER BUCKLE FAILS TO OPERATE PROPERLY, OWNERS SHOULD PROMPTLY CONTACT THEIR AUTHORIZED DEALER TO SCHEDULE AN APPOINTMENT TO HAVE THE BUCKLE REPLACED OR REPAIRED FREE OF CHARGE.
Recall 98V284000 started on /Date(910242000000-0500)/.
Summary: VEHICLE DESCRIPTION: PASSENGER VEHICLES EQUIPPED WITH BOSE REAR SPEAKERS THAT HAVE AN INTEGRAL AMPLIFIER. A CONDUCTIVE BRIDGE CAN FORM BETWEEN TWO LINES OF THE CIRCUIT BOARD PATTERN WHEN THERE IS ACCUMULATED ELECTROLYTE LEAKED FROMA CAPACITOR AND HIGH HUMIDITY CONDITIONS. THIS CAN CLOSE A TRANSISTOR ON THE CIRCUIT BOARD WHICH CAUSES OVERHEATING.
Consequence: THIS CONDITION COULD RESULT IN SMOKE OR FLAME AND POSSIBLY THE SPEAKER CATCHING FIRE.
Remedy: DEALERS WILL REPLACE THE CIRCUIT BOARD WITH A NEW BOARD THAT HAS BEEN COATED.