1996 Ford Aerostar Review
1996 Ford Aerostar is a Sports Van style car measuring 174.90 in length and 72.90 in height. Made in United States, 1996 Ford Aerostar has 4 trims priced by the manufacturer at 20,655 with just total of 6 recalls in the past 1996 Ford Aerostar. It’s seating 7 people with doors and a rank size of 21.00 gallon. The engine is 4.0L V6 OHV 12V and uses 17 of gasoline in the city and 17 on highways.
Vin Numbers
- 1FMDA31X0TZA88717
- 1FMDA31X1TZB93704
- 1FMDA31X1TZC03910
- 1FMDA31X6TZB49116
- 1FMDA31X8TZC09025
- 1FMDA31X9TZC05744
- 1FMDA31XXTZB94883
- 1FMDA31X6TZA96692
- 1FMDA31X4TZC01374
- 1FMDA31X9TZB35484
Safety and Reliability
NHTSA Crash Test
* National Highway Traffic Safety AdministrationIIHS Crash Test
* Insurance Institute for Highway SafetySafety & Recalls
Recall 06E022000 started on /Date(1142226000000-0500)/.
Summary: CERTAIN AFTERMARKET BRAKE HYDRAULIC MASTER CYLINDERS SOLD AS REPLACEMENT BRAKE CYLINDERS FOR CERTAIN FORD, DAIMLERCHRYSLER, AND JEEP PASSENGER VEHICLES. THESE BRAKE CYLINDERS WERE SOLD UNDER THE BRAND NAMES OF NAPA, RAYBESTOS, AIMCO, AC DELCO, CARQUEST, BENDIX, AND WAGNER. ONLY PRODUCTS THAT WERE MANUFACTURED FROM JULY 27, 2005 THROUGH JANUARY 17, 2006 (DATE CODES 0529 THROUGH 0602) ARE SUBJECT TO THIS RECALL. WHEN SUBJECT TO VERY COLD TEMPERATURES, AN INTERNAL SEAL IN THE MASTER CYLINDER COULD LOSE FLEXIBILITY AND MAY CAUSE BRAKE FLUID TO LEAK.
Consequence: LOSS OF BRAKE FLUID CAN LEAD TO A DECREASE IN BRAKE LINE PRESSURE AND AN INCREASE IN STOPPING DISTANCE, WHICH CAN RESULT IN A VEHICLE CRASH.
Remedy: AFFINIA (BRAKE PARTS, INC.) WILL REPLACE THE SUBJECT BRAKE HYDRAULIC MASTER CYLINDERS FREE OF CHARGE. THE RECALL BEGAN ON MARCH 20, 2006. OWNERS CAN CONTACT AFFINA GROUP CUSTOMER SERVICE AT 1-800-323-0354.
Recall 96V070000 started on /Date(830145600000-0400)/.
Summary: WHEN IN THE SECONDARY LATCHED POSITION, THE DRIVER DOOR LATCHES MAY OPEN WHEN SUBJECTED TO TRANSVERSE LOADS LESS THAN THAT SPECIFIED IN FMVSS NO. 206, "DOOR LOCKS AND DOOR RETENTION COMPONENTS."
Consequence: THE DRIVER'S DOOR, WHEN CLOSED ONLY TO THE SECONDARY LATCHED POSITION, MAY NOT SUSTAIN A 1,000 POUND TRANSVERSE LOAD.
Remedy: DEALERS WILL INSPECT AND, IF NECESSARY, REPLACE THE DRIVER DOOR LATCH.
Recall 96V161000 started on /Date(841291200000-0400)/.
Summary: THE CERTIFICATION LABELS ON THE INVOLVED VEHICLES HAS INCORRECT REAR TIRE INFLATION PRESSURE DESIGNATIONS. THIS DOES NOT COMPLY WITH FMVSS NO. 120, "TIRE SELECTION AND RIMS FOR MOTOR VEHICLES OTHER THAN PASSENGER CARS."
Consequence: INCORRECT INFLATION PRESSURES COULD CAUSE PREMATURE WEAR OF THE REAR TIRES. .
Remedy: OWNERS WILL BE PROVIDED WITH CORRECT CERTIFICATION LABELS AND INSTRUCTIONS FOR INSTALLING THESE LABELS. DEALERS CAN INSTALL THIS LABEL IF THE OWNER SO DESIRES.
Recall 97V204000 started on /Date(879397200000-0500)/.
Summary: VEHICLE DESCRIPTION: ALL WHEEL DRIVE PASSENGER MINIVANS. THESE VEHICLES CAN DEVELOP POWERTRAIN BENDING RESONANCE OR TRANSFER CASE OUTPUT SHAFT BUSHING DISPLACEMENT. THE POWERTRAIN BENDING RESONANCE OR THE OUTPUT SHAFT BUSHING DISPLACEMENT CAN RESULT IN STRUCTURAL FAILURE OF THE TRANSMISSION AND/OR TRANSFER CASE. FLUID EXPLUSION, DRIVESHAFT SEPARATION OR LOSS OF VEHICLE DRIVE CAN RESULT.
Consequence: THIS CONDITION CAN CAUSE A LOSS OF VEHICLE CONTROL, AND, IF THE EXPELLED FLUID CONTACTS THE EXHAUST SYSTEM, A VEHICLE FIRE COULD OCCUR.
Remedy: DEALERS WILL INSTALL A NEW TRANSFER CASE REAR OUTPUT SHAFT BUSHING AND AN ALUMINUM DRIVESHAFT WILL BE INSTALLED.
Recall 98E010000 started on /Date(892008000000-0400)/.
Summary: EQUIPMENT DESCRIPTION: AFTERMARKET BRAKE ROTORS FOR USE ON CERTAIN FORD AND MAZDA TRUCKS. CRACKED CASTINGS CAUSED CRACKS TO APPEAR ON THE OUTER DIAMETER OF THE ROTOR HAT OR AROUND THE STUD HOLE.
Consequence: LOSS OF BRAKING CAN RESULT.
Remedy: AIMCO WILL REIMBURSE CONSUMERS/INSTALLERS FOR THE COST OF REPLACEMENT ROTORS AND INSTALLATION. CONSUMERS ARE REQUESTED TO RETURN TO THE LOCATION WHERE THE ROTORS WERE ORIGINALLY PURCHASED/INSTALLED FOR REPLACEMENT.
Recall 99V029000 started on /Date(918536400000-0500)/.
Summary: VEHICLE DESCRIPTION: MINI VANS. THESE VEHICLES WERE PRODUCED WITH A HIGHER THAN SPECIFIED ELECTRICAL LOAD THROUGH THE ACCESSORY POWER FEED CIRCUIT. THE POTENTIAL FOR CONTACT BETWEEN THE B2 (BATTERY), A2 (ACCESSORY), AND P1 (PROOF) CIRCUITS CAN OCCUR, CREATING A SHORT CIRCUIT, ALLOWING CURRENT TO FLOW THROUGH THE GROUND WIRE.
Consequence: THIS CAN CAUSE OVER HEATING AND THE POTENTIAL FOR A VEHICLE FIRE.
Remedy: DEALERS WILL INSTALL A JUMPER HARNESS WITH A RELAY WHICH WILL RE-ROUTE AND ACTIVATE ALL A2 ACCESSORIES THROUGH THE RELAY.