1984 Ford Ranger Review
1984 Ford Ranger is a Regular Cab Pickup 2-dr style car .Made in United States, 1984 Ford Ranger has 2 trims priced by the manufacturer at 0 with just total of 8 recalls in the past 1984 Ford Ranger. It’s seating No data people with 2 doors and a rank size of No data gallon. The engine is 2.8L V6 OHV .
Vin Numbers
- 1FTBR11S9EUB74797
- 1FTCR11S7EUB02128
- 1FTCR11S1EUA48938
- 1FTCR11S6EUD80177
- 1FTCR11S3EUB29620
- 1FTCR11S5EUD90148
- 1FTCR11S9EUC93857
Safety & Recalls
Recall 07E064000 started on /Date(1188187200000-0400)/.
Summary: CERTAIN FEDERAL-MOGUL AFTERMARKET FUEL PUMPS SOLD UNDER THE BRAND NAMES OF CARTER, ACCUFLOW, NAPA, TRUFLOW, PARTS DEPO, AND PARTS MASTER, SHIPPED BETWEEN AUGUST 2006 AND JULY 2007 FOR USE ON THE VEHICLES LISTED ABOVE. THE FUEL PUMP DIAPHRAGM IN CERTAIN PRODUCTION RUNS MAY HAVE BEEN IMPROPERLY INSTALLED OR INADEQUATELY TESTED WHICH MAY CAUSE THE FUEL PUMP TO LEAK.
Consequence: A LEAKING FUEL PUMP COULD CREATE A VEHICLE FIRE HAZARD.
Remedy: FEDERAL-MOGUL WILL NOTIFY OWNERS AND REPLACE THE DEFECTIVE FUEL PUMPS FREE OF CHARGE. THE RECALL BEGAN ON OCTOBER 15, 2007. OWNERS CAN CONTACT FEDERAL-MOGUL AT 248-354-7700.
Recall 83V115000 started on /Date(437029200000-0500)/.
Summary: VEHICLES MAY HAVE FUEL OR VAPOR LINE DAMAGE CAUSED WHEN AN INCORRECT PROCEDURE WAS USED IN TIGHTENING BOLTS ON ADJACENT COMPONENTS DURING ASSEMBLY. THE FUEL TANK MAY BECOME DAMAGED DUE TO A LOOSE CROSS MEMBER THAT SUPPORTS IT.
Consequence: Not Defined
Remedy: VEHICLES WILL BE INSPECTED AND, WHEN NECESSARY, FUEL AND VAPOR LINES WILL BE REPLACED AND THE CROSS MEMBER WILL BE TIGHTENED.
Recall 84V104000 started on /Date(463291200000-0400)/.
Summary: WEIGHT RATING INFORMATION IS INCORRECT ON VEHICLE MANUAL LABELS AND RATING DECALS.
Consequence: Not Defined
Remedy: DEALERS WILL BE PROVIDED WITH THE REVISED VEHICLE INFORMATION. IF VEHICLE WEIGHT IS FOUND TO BE GREATER THAN THAT SPECIFIED ON WEIGHT RATING, THE AFFECTED VEHICLE"S REAR AXLE MAY BE REPURCHASED FROM FORD. A PRICE ADJUSTMENT WILL ALSO BE MADE IF APPROPRIATE.
Recall 84V111000 started on /Date(464932800000-0400)/.
Summary: SECONDARY HOOD LATCH COMPONENTS MAY HAVE BEEN IMPROPERLY POSITIONED DURING ASSEMBLY. IF THE HOOD IS NOT CLOSED TIGHTLY, OR IS INADVERTENTLY RELEASED, THE SECONDARY LATCH MAY NOT WORK AND THE HOOD MAY FLY UP WITHOUT PRIOR WARNING.
Consequence: Not Defined
Remedy: THE HOOD ASSEMBLY WILL BE INSPECTED AND THE HOOD AND LATCH COMPONENTS WILL BE ADJUSTED, IF NECESSARY, WITHOUT CHARGE TO THE OWNER.
Recall 84V082000 started on /Date(458193600000-0400)/.
Summary: IF TRUCK IS STRUCK FROM THE SIDE, THE CAP ON THE FUEL TANK COULD BECOME UNSEALED, ALLOWING UNSAFE LEAKAGE OF FUEL. THIS IS A FAILURE TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD 301, "FUEL SYSTEM INTEGRITY". LEAKAGE CAN BE CAUSED BY AN ORANGE-COLORED PLASTIC DIESEL FUEL INFORMATION RING WHICH IS FOUND AROUND THE FUEL TANK NECK, OR BY THE TETHER.
Consequence: Not Defined
Remedy: UPON INSPECTION, FUEL CAP TETHERS WILL BE REPLACED OR DIESEL FUEL INFORMATION RINGS WILL BE REMOVED.
Recall 83V134000 started on /Date(440744400000-0500)/.
Summary: THE BOLTS THAT ATTACH THE D-SHAPED RING FOR THE SHOULDER BELT ARE INADEQUATELY SUPPORTED BY THE MATERIAL IN WHICH THEY ARE MOUNTED. THE ATTACHMENT DOES NOT COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 210, "SEAT BELT ASSEMBLY ANCHORAGES".
Consequence: Not Defined
Remedy: DEALERS WILL INSTALL NEW ATTACHING HARDWARE TO IMPROVE THE STRENGTH OF THE MOUNTING.
Recall 84V023000 started on /Date(447397200000-0500)/.
Summary: COMPONENTS IN THE LOCKING HUBS WERE IMPROPERLY HEAT-TREATED AND MAY CRACK OR FRACTURE UPON ENGAGEMENT OF THE FRONT DRIVE AXLES. THE BROKEN COMPONENT ON THE LEFT FRONT WHEEL MAY BECOME JAMMED AGAINST THE NUT.
Consequence: Not Defined
Remedy: CAM ASSEMBLIES IN FRONT WHEEL AUTOMATIC LOCKING HUBS WILL BE REPLACED.
Recall 98E010000 started on /Date(892008000000-0400)/.
Summary: EQUIPMENT DESCRIPTION: AFTERMARKET BRAKE ROTORS FOR USE ON CERTAIN FORD AND MAZDA TRUCKS. CRACKED CASTINGS CAUSED CRACKS TO APPEAR ON THE OUTER DIAMETER OF THE ROTOR HAT OR AROUND THE STUD HOLE.
Consequence: LOSS OF BRAKING CAN RESULT.
Remedy: AIMCO WILL REIMBURSE CONSUMERS/INSTALLERS FOR THE COST OF REPLACEMENT ROTORS AND INSTALLATION. CONSUMERS ARE REQUESTED TO RETURN TO THE LOCATION WHERE THE ROTORS WERE ORIGINALLY PURCHASED/INSTALLED FOR REPLACEMENT.