1983 Ford Econoline Review
1983 Ford Econoline is a Motorized Cutaway style car .Made in United States, 1983 Ford Econoline has 5 trims priced by the manufacturer at 0 with just total of 6 recalls in the past 1983 Ford Econoline. It’s seating No data people with doors and a rank size of No data gallon. The engine is 4.9L L6 OHV 12V .
Vin Numbers
- 1FTDE14Y0DHB60895
- 1FTDE15Y7DHA29588
- 1FTDE14F4DHA54934
- 1FTEE14GXDHB42075
- 1FTDE14F1DHA18117
- 1FTDE14F7DHA01810
- 1FTDE14F5DHB69946
- 1FTDE14G3DHA08911
- 1FTDE14Y5DHB61587
- 1FTDE14G8DHB26906
- 1FDDE14F6DHB11677
- 1FTDE14Y2DHB77858
- 1FTDE14Y0DHA87432
- 1FTDE14Y5DHB59306
- 1FTDE14Y8DHA87436
- 1FTDE14Y0DHB60895
- 1FTDE15Y7DHA29588
- 1FTDE14F4DHA54934
- 1FTEE14GXDHB42075
- 1FTDE14F1DHA18117
- 1FTDE14F7DHA01810
- 1FTDE14F5DHB69946
- 1FTDE14G3DHA08911
- 1FTDE14Y5DHB61587
- 1FTDE14G8DHB26906
- 1FDDE14F6DHB11677
- 1FTDE14Y2DHB77858
- 1FTDE14Y0DHA87432
- 1FTDE14Y5DHB59306
- 1FTDE14Y8DHA87436
Safety & Recalls
Recall 07E064000 started on /Date(1188187200000-0400)/.
Summary: CERTAIN FEDERAL-MOGUL AFTERMARKET FUEL PUMPS SOLD UNDER THE BRAND NAMES OF CARTER, ACCUFLOW, NAPA, TRUFLOW, PARTS DEPO, AND PARTS MASTER, SHIPPED BETWEEN AUGUST 2006 AND JULY 2007 FOR USE ON THE VEHICLES LISTED ABOVE. THE FUEL PUMP DIAPHRAGM IN CERTAIN PRODUCTION RUNS MAY HAVE BEEN IMPROPERLY INSTALLED OR INADEQUATELY TESTED WHICH MAY CAUSE THE FUEL PUMP TO LEAK.
Consequence: A LEAKING FUEL PUMP COULD CREATE A VEHICLE FIRE HAZARD.
Remedy: FEDERAL-MOGUL WILL NOTIFY OWNERS AND REPLACE THE DEFECTIVE FUEL PUMPS FREE OF CHARGE. THE RECALL BEGAN ON OCTOBER 15, 2007. OWNERS CAN CONTACT FEDERAL-MOGUL AT 248-354-7700.
Recall 85V061000 started on /Date(484891200000-0400)/.
Summary: WHEN FRONTALLY IMPACTED INTO A FIXED BARRIER AT 30 MPH, AS SPECIFIED IN FEDERAL MOTOR VEHICLE SAFETY STANDARD (FMVSS) NO. 301, THE LEFT FRAME RAILS OF SUCH VEHICLES MAY DISPLACE INBOARD, PINCHING THE FUEL/WATER SEPARATOR CANISTER BETWEEN THE FRAME RAIL AND ENGINE SUFFICIENTLY TO DISPLACE THE FUEL/WATER SEPARATOR DRAIN ROD, ALLOWING THE CONTENTS OF THE CANISTER TO DRAIN. CONSEQUENCE OF DEFECT: FUEL LEAK DURING OR AFTER A CRASH INCREASES THE POSSIBILITY OF A FIRE.
Consequence: Not Defined
Remedy: INSTALL A CANISTER SHIELD, A REVISED DESIGN DRAIN ROD SHIELD, AND MODIFY FUEL/WATER SEPARATOR MOUNTING BRACKET.
Recall 83V028000 started on /Date(415861200000-0500)/.
Summary: THE PARKING GEAR MAY NOT ENGAGE, EVEN THOUGH THE GEAR SHIFT LEVER IS PLACED IN THE "PARK" POSITION. THIS OCCURS IF THE LINKAGE INSIDE THE TRANSMISSION THAT ACTUATES THE PARK GEAR WAS IMPROPERLY MANUFACTURED. A PIN THAT RETAINS COMPONENTS ON A LINKAGE (ACTUATING) ROD COULD BREAK AND THE LINKAGE MAY NOT ENGAGE THE PARKING GEAR.
Consequence: Not Defined
Remedy: DEALER WILL INSPECT AND, IF NECESSARY, REPLACE THE PARKING PAWL ACTUATING ROD ASSEMBLY.
Recall 82V124000 started on /Date(408603600000-0500)/.
Summary: SOME OF THE INVOLVED VEHICLES MAY HAVE A DIODE IN THE ELECTRICAL FUEL PUMP CIRCUIT THAT MAY SHORT DURING ENGINE STARTING DUE TO INADEQUATE CAPACITY TO WITHSTAND CURRENT DRAW. A SHORT CIRCUIT WOULD RESULT IN NORMAL ENGINE STARTING, BUT THE PUMP WILL NOT CONTINUE TO SUPPLY THE ENGINE WITH FUEL.
Consequence: Not Defined
Remedy: THE DEALER WILL REPLACE DEFECTIVE ELEMENT IN THE ELECTRICAL FUEL PUMP CIRCUIT WITH A NEW RELAY FEED WIRING ASSEMBLY WHICH CONTAINS A LARGER CAPACITY DIODE, FREE OF CHARGE.
Recall 87V144000 started on /Date(558158400000-0400)/.
Summary: VEHICLES ARE SUBJECT TO EXCESSIVE UNDERHOOD TEMPERATURES AND FUEL SYSTEM PRESSURES IN SEVERE DUTY APPLICATIONS.
Consequence: THIS CREATES POTENTIAL FOR FUEL EXPULSION FROM THE FUELFILLER PIPE WHICH IN THE PRESENCE OF AN IGNITION SOURCE, COULD RESULT IN AFIRE.
Remedy: INSTALL MODIFICATION KITS TO MINIMIZE POSSIBILITY OF FUEL EXPULSION AND TO SHIELD UNDERBODY COMPONENTS FROM EXHAUST SYSTEM HEAT.
Recall 87V113000 started on /Date(553838400000-0400)/.
Summary: EXPULSION OF FUEL DUE TO OVERPRESSURIZATION.
Consequence: FUEL OR FUEL VAPORS IN THE PRESENCE OF AN IGNITIONSOURCE CAN CAUSE A FIRE.
Remedy: MODIFICATION OF THE BASE FUEL VENTING AND EMISSION CONTROL SYSTEM TO REDUCE OPERATING TEMPERATURES AND FUEL SYSTEM PRESSURES.