1986 Ford Ranger Review

Recall 88V145000 started on /Date(589176000000-0400)/.

Summary: WIRING FOR THE POWER LUMBAR SEAT SYSTEM WAS ROUTED DIRECTLY BENEATH THE SEAT CUSHION SPRINGS AND MAY BE ABRADED BY THE SPRINGS.

Consequence: THIS COULD RESULT IN A SHORT CIRCUIT WHICH MAY CREATESUFFICIENT HEAT TO START A FIRE IN THE SEAT CUSHION PAD AND/OR TRIM COVER.

Remedy: INSTALL A FUSE WITHIN THE POWER LUMBAR ELECTRICAL CIRCUIT.

Recall 87V139000 started on /Date(557726400000-0400)/.

Summary: SPRING LOCK FUEL LINE COUPLING MAY NOT BE PROPERLY ENGAGED.

Consequence: COUPLING COULD DISENGAGE DUE TO FUEL PRESSURE,VIBRATION, AND ENGINE MOVEMENTS; THIS WOULD CAUSE LOSS OF FUEL WHICH, INPRESENCE OF AN IGNITION SOURCE, CREATES A FIRE RISK.

Remedy: INSTALL RETAINER CLIPS OVER THE COUPLINGS TO PREVENT COUPLING SEPARATION AND FUEL LEAKAGE.

Recall 85V116000 started on /Date(496382400000-0400)/.

Summary: THE ELECTRONIC ENGINE CONTROL WIRING HARNESS INSULATION MAY BE DAMAGED DUE TO COPPER SPIKES PRODUCED DURING THE WELDING OF ITS WIRES. THIS CREATES A POTENTIAL FOR A SHORT CIRCUIT BETWEEN THE WIRES WHICH ENERGIZE THE FUEL PUMP, CAUSING SOME FUEL INJECTORS TO OPEN, DISCHARGING FUEL INTO THE ENGINE. CONSEQUENCE OF DEFECT: FUEL DISCHARGED INTO THE ENGINE WOULD EVENTUALLY LEAK THROUGH THE EXHAUST SYSTEM TO THE GROUND. THIS COULD RESULT IN A FIRE IF A SOURCE OF IGNITION IS PRESENT.

Consequence: Not Defined

Remedy: REPAIR WIRING HARNESS, CHECK ENGINE AND CATALYST FOR DAMAGE.

Recall 85V130000 started on /Date(498456000000-0400)/.

Summary: NYLON FUEL LINES ON THE FUEL RETURN SIDE OF THE FUEL PRESSURE REGULATOR ASSEMBLY MAY CRACK. CONSEQUENCE OF DEFECT: FUEL LINE COULD LEAK AND, IF AN IGNITION SOURCE IS PRESENT, CREATE THE POTENTIAL FOR A FIRE.

Consequence: Not Defined

Remedy: REPLACE NYLON FUEL HOSES WITH RUBBER HOSES.

Recall 98E010000 started on /Date(892008000000-0400)/.

Summary: EQUIPMENT DESCRIPTION: AFTERMARKET BRAKE ROTORS FOR USE ON CERTAIN FORD AND MAZDA TRUCKS. CRACKED CASTINGS CAUSED CRACKS TO APPEAR ON THE OUTER DIAMETER OF THE ROTOR HAT OR AROUND THE STUD HOLE.

Consequence: LOSS OF BRAKING CAN RESULT.

Remedy: AIMCO WILL REIMBURSE CONSUMERS/INSTALLERS FOR THE COST OF REPLACEMENT ROTORS AND INSTALLATION. CONSUMERS ARE REQUESTED TO RETURN TO THE LOCATION WHERE THE ROTORS WERE ORIGINALLY PURCHASED/INSTALLED FOR REPLACEMENT.